例句與造句

1. The results show : ( 1 ) around 600 is a key carbonization temperature for bamboo
   結果表明： ( 1 ) 600左右是竹材炭化的一個非常重要的熱處理溫度。
2. The quality of buffer layer and thin films was analyzed by afm , xrd , rheed and xps respectively . the effect of the experimental parameters such as carbonization time , working pressure , c source gas flow rate , carbonization temperature , different carbonization gas and substrate on the carbonization process was studied firstly . it was observed that the size of particles was increased with the increase of carbonization time and the rms was opposite , but the trend was reduced while the carbonization time was long enough ; the size of particles was increased with the increase of working pressure too , and choosing a proper working pressure could get a smooth surface ; the size of particles was unobviously changed while the gas flow rate was low , but it was notability increased with the increase of gas flow rate while the gas flow rate was high enough , and a smooth surface could be also obtained by choosing a proper gas flow rate ; with the increase of carbonization temperature , the size of particles was increased , the rms is decreased and a good single - crystalline carbonization layer could be obtained , but a rough surface was formed at a excessive high temperature ; the rms of
   對于碳化工藝,側重研究了碳化時間、反應室氣壓、 c源氣體的流量、碳化溫度以及不同種類的c源氣體、基片取向等因素對碳化層質量的影響,研究結果表明:隨著碳化時間的增長,碳化層的晶粒尺寸隨之變大,表面粗糙度隨之降低,但當碳化到一定時間之后,碳化反應減緩,碳化層的晶粒尺寸以及表面粗糙度的變化幅度變小;碳化層的晶粒尺寸隨反應室氣壓的升高而變大,適中的反應室氣壓可得到表面比較平整的碳化層;在c源氣體的流量相對較小時,碳化層的晶粒尺寸隨氣體流量的變化不明顯,但當氣體流量增大到一定程度時,碳化層的晶粒尺寸隨氣體流量的增大而明顯變大,同時,適中的氣體流量得到的碳化層表面粗糙度較低;碳化溫度較低時,碳化層的晶粒取向不明顯,隨著碳化溫度的升高,碳化層的晶粒尺寸明顯變大,且有微弱的單晶取向出現,但取向較差,同時,適中的碳化溫度可得到表面平整的碳化層;相比于c _ 2h _ 2 ,以ch _ 4作為c源氣體時得到的碳化層表面平整得多;比起si ( 100 ) ,選用si ( 111 )作為基片生長的碳化層的晶粒取向一致性明顯更好。
3. It's difficult to find carbonization temperature in a sentence. 用carbonization temperature造句挺難的